Installation Guide eSATA 3Gbps Dual ports Express Card/34 Host GPS702e3W6 1 PART NO.
Table of Contents Introduction 4 Features 5 Package Contents 6 Software Installation 7 Federal Communications Commission (FCC) Statement 10 CE Statement 12 Limited Warranty 13 Contact 14 3
Introduction The ExpressCard Host allows you to upgrade your Notebook computer with up to two SATA II Channels. The board provides a 2.5Gbps ExpressCard interface on the host side, and dual fully compliant SATA II 3Gbps ports on the device side to access Serial ATA mobile external and internal storage devices such as: hard drives, ZIP drives, CD-ROMs, CD-RWs and DVD-ROM drives.
Features • • • • • • • • • • • • • • • • • External SATA II (eSATA) Connector 48 bits LBA can Break Capacity-Limit to Support HDD larger than 137GB Supports 1-lane 2.5Gbps ExpressCard/34 Hot-plug capability Supports SATA II transfer rate of 3.0Gbps Fully compliant with Serial ATA 1.
Package Contents • • • SATA ExpressCard Host Adapter Quick Start Guide Driver CD 6
Software Installation Windows XP Installation 1. Insert the SATA Card into an available slot. Connect the serial ATA cable(s) between the SATA port and serial ATA device(s). 2. Windows will display the ‘Found New Hardware Wizard’. A new ‘Mass Storage controller’ will become detected. 3. Insert the Driver CD into your CD-ROM/DVD Drive. 4. Select “Install from a list or specific location (Advanced)”, and click “Next”.
5. Select “Search for the best driver in these locations”, and check “Include this location in the search:” Be sure to uncheck the other available boxes. 6. Type the appreciate media drive letter and select the “Browse” option. 7. Specify a location [CD Drive Letter]:\SATA Express_2Port \Sil3132 \ WinXP_2000_2003_NT, and click OPEN then select OK. 8. When the wizard indicates that it found a driver for the device click ‘Next’. 9.
Verify Windows XP Installation 1. Right click on the ‘My Computer’ icon, select ‘Properties’, left click on the ‘Hardware’ tab, and select the ‘Device Manager’ button. 2. Double click on ‘SCSI and RAID Controllers’, If there is no yellow ‘! ‘ or ‘ ? ‘ in front of ‘Silicon Image SiI 3132 SATALink Controller’, the driver is functioning properly.
Federal Communications Commission (FCC) Statement Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1. this device may not cause interference and 2. this device must accept any interference, including interference that may cause undesired operation of the device.
CE Statement CE Statement This device has been tested and found to comply with the requirements set up in the council directive on the approximation of the law of member states relating to EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC and R&TTE Directive 99/5/EC.
Limited Warranty The manufacturer, IOGEAR, makes NO warranty or representation, whether express or implied, regarding the contents, use or suitability of this software, disk or documentation. IOGEAR specifically disclaims any and all warranties regarding the quality and performance of this software, disk or documentation including, but not limited to the implied warranty of merchantability and implied warranty of fitness for a particular purpose.
Contact Toll Free: (866) 9-IOGEAR Phone: (949) 453-8782 23 Hubble Irvine, CA 92618 USA www.iogear.com support@iogear.
About Us FUN IOGEAR offers connectivity solutions that are innovative, fun, and stylish, helping people enjoy daily life using our high technology products. GREEN IOGEAR is an environmentally conscious company that emphasizes the importance of conserving natural resources. The use of our technology solutions helps reduce electronic waste. HEALTH IOGEAR supports healthy and fit lifestyles. By integrating products with the latest scientific developments, IOGEAR’s solutions enhance the life of end-users.
