Owner's manual

11
Operation – To switch between connected computers
Note: Software installation is not mandatory for
the USB 2.0 Peripheral Sharing Switch to function.
The device supports manual operation. Manual
operation and software-based operation operate
independently; commands from one will not
override the other.
For GUB231:
To switch the connection to the USB device
between the two computers, press the port
selection button located on the top center of
the Sharing Switch. The selected port LED will
ashandtheSharingSwitchwillbeep.Afterfour
seconds,theashingwillstopandtheLEDwill
become steady, the port switch is completed
successfully.
For GUB431:
To switch the connection to the USB device
between the four computers, press the
corresponding port button located on the top of
the Sharing Switch. The selected port button LED
willashandtheSharingSwitchwillbeep.After
fourseconds,theashingwillstopandtheLED
will become steady, then port switch is completed
successfully.