User manual

Overview

Prepare to Software Installation - Windows

Receiver Base Front View

1. Power / Signal

Indicator Light

2. Wireless Connection

LED Light

Receiver Base Back View

1. DC Power Input

2. HD Port

3. D-Sub 15Pin (VGA)

4. 3.5mm Audio Out

5. USB 2.0 Port

6. Antenna

PC Adapter

1. USB 2.0

If your PC contains a previous IOGEAR Wireless Software or other Wireless USB

driver installation, please perform a proper uninstall procedure using the Windows

Control Panel.

Prior to Software Installation:

1. It is important to make sure there is no prior installation of Wireless USB or Display Link

software from IOGEAR or other com¬panies. IF YOU HAVE THIS SOFTWARE IN YOUR

SYSTEM, THIS WILL CAUSE THE IOGEAR WIRELESS SOFTWARE NOT TO WORK

PROPERLY.

2. Go to Control Panel>Programs and Features and look through your programs to ensure

you do not see any UWB wireless programs.

3. If you see any UWB wireless programs listed under program name, uninstall it by

highlighting and clicking on the Uninstall tab.

4. The installation software requires .NET Framework version 2.0 (or later) to be installed on

the computer. In case it is not installed it may be downloaded from the following location:

http://www.microsoft.com/downloads/details.aspx?FamilyID=0856EACB-4362-4B0D-

8EDD-AAB15C5E04F5&displaylang=en

5. Anti Virus software set to very high security may prevent the installer from running. It is

recommended to temporarily disable the Anti viruses SW during the installation.

1 1

2 3 4 652