Quick Start Guide

Pairing Additional Transmitters
The Wireless HDMI Receiver can be paired with up to 3 additional
Wireless HDMI Transmitters (Part #GWHDSTX sold separately).
Please visit http://www.iogear.com/product/GWHDSTXB/ for more
information.
Note: When adding an additional transmitter:
1. Look at your serial numbers to see if * mark precedes the serial
number on the receiver. If there is a *, the transmitter MUST also
have * mark precedes the serial number or the transmitter and
the receiver will not pair. Conversely if there is no * mark before
the serial number of the receiver, then the transmitter must also
be absent of the * mark before the serial number.
2. Make sure that the power to any existing transmitters already
linked to the receiver is powered off before entering the receiver
into pairing mode.
Pairing Mode for the Transmitter:
1. Once the transmitter is connected to the computer or source
player and is powered on, the LED will start to blink fast. Press
and hold the Pairing Button. You can now release the pairing
button
2. The transmitter is in Pairing Mode once the Power LED flashes
slowly (1 flash/sec).