User Guide

Diagnostics and Troubleshooting
Removing Stuck Cartridges
56 ValueLoader LTO Tape Autoloader User Manual
2 Remove the power and SCSI cables from their connectors on
the back panel of the ValueLoader.
3 Remove the ValueLoader from its rack slot, if applicable, and
place it on a table or other flat work surface.
4 If the ValueLoader is a rackmounted, remove the front cover
screws that secure the mounting brackets from both sides of
the ValueLoader, as shown in figure 15
.
Figure 15 Removing
Mounting Brackets
(Left Side Shown)
5 Remove the seven screws that secure the ValueLoader cover:
five on the back panel and one on each side of the
ValueLoader.
6 Remove the top cover by lifting it from the back and easing it
out from under the front panel display cover.
Warning: To prevent injury, disconnect all cables from the
ValueLoader before removing the ValueLoader
cover. Keep fingers away from the ValueLoader
fan.