How to Guide

Listening to the Radio

Air CD Pro comes with a built-in FM radio.

To turn on the radio and select a station:

1. Remove the Antenna from the clips on the rear panel and extend it (see Setup for more details if

needed).

2. Make sure that Air CD Pro is in Radio Mode (see Selecting the Audio Input Mode for more

details if needed). The Display will show the currently selected radio station number.

3. Adjust the radio station number by doing one of the following:

• Turn the Tune Knob left or right to manually change the station number in increments of 0.1

MHz.

• Press and hold the Previous or Next button to seek forward or backward. When “seeking,”

Air CD Pro will skip to the nearest station number with a clear signal.

• Press and release the Previous or Next button to go to the previous or next preset station.

See Presets below to learn more about saving preset stations.

If you are having trouble getting a clear signal from the radio, try moving the Antenna. Alternatively,

you can try switching the radio from stereo to mono, which may reduce static interference for some

radio stations.

To switch the radio signal between stereo and mono, press the Repeat/FM ST button. When

you set the radio to stereo, the Display will temporarily read StEr, and the Stereo Symbol will be lit.

When you set the radio to mono, the Display will temporarily read Off, and the Stereo Symbol will

not be lit.

Presets

With the radio presets feature, you can assign a radio station one of 20 preset numbers on Air CD

Pro, allowing you to easily access the station at the touch of the Previous and Next buttons.

To save a radio station as a preset:

1. Enter Radio Mode and select a radio station (as described above).

2. Press and hold the Preset/Prog button. The Prog Icon on the left side of the Display will be

solidly lit, and the Display will flash one of the preset numbers (shown as P01–P20) to indicate

that the presets are being edited.

3. Use the Tune Knob or the Previous/Next buttons to change the preset number that you would

like to save the station to. The preset numbers will update on the Display as you scroll through

them. There are 20 preset numbers that you can choose between (P01–P20).

4. When you’ve identified the preset number to which you’d like to save the station, press and

release the Preset/Prog button. The Prog Icon will turn off and the Display will return to

showing the radio station number.

To automatically store the 20 radio stations with the strongest signals as presets, press and

hold the Play/Pause button while Air CD Pro is in Radio Mode. Air CD Pro will then travel through

the entire FM band and assign the station numbers with the strongest signals to each of the 20

available presets. The Display will update as Air CD Pro seeks through the stations. Once the

scanning is complete, the Display will return to showing the currently selected station number.