How to Guide

Pairing Air CD Pro with a Bluetooth Speaker

When paired with a Bluetooth speaker, Air CD Pro can send audio to the speaker from the radio, a

CD, or an auxiliary device.

Note: Air CD Pro cannot send audio from a Bluetooth device to a Bluetooth speaker. If you are

paired with a Bluetooth speaker and you switch the audio input mode to Bluetooth, Air CD Pro will

unpair from the speaker.

To pair Air CD Pro with a Bluetooth speaker:

1. Make sure that Air CD Pro is in Radio, CD, or Aux Mode, depending on what you would like to

listen to (see Selecting the Audio Input Mode for more details if needed).

2. Power on your Bluetooth speaker and make sure that it is ready to pair with Air CD Pro.

3. Press the Bluetooth button. bLUE will begin flashing on the Display to indicate that Air CD Pro

is searching for a speaker to pair with. Once Air CD Pro successfully pairs with the speaker, the

Display will alternate between showing bLUE and showing the default information for the

selected audio input mode.

Note: It may take up to 30 seconds for the pairing to complete. The closer the speaker is to Air

CD Pro during the pairing process, the more quickly the two items will pair.

4. Once Air CD Pro and the speaker are paired, you can initiate playback of the CD, auxiliary

device, or radio station that you would like to hear. If you do not hear anything and your

Bluetooth speaker has a play/pause button, try pressing the play/pause button on the Bluetooth

speaker. To control the output level, adjust the volume on your Bluetooth speaker (if applicable)

or on Air CD Pro.

To pair with a different Bluetooth speaker, repeat steps 3–4. You should take the speaker with

which Air CD Pro was previously paired and power it off, move it out of range, disable its Bluetooth

capacity, or go to its settings menu and select to “Forget” Air CD Pro.

To unpair a Bluetooth speaker and/or stop Air CD Pro from searching for a Bluetooth speaker

to pair with, press and hold the Bluetooth button.

Setting the Clock

When Air CD Pro is in standby, the Display will show the time.

To set the clock on the Display:

1. Make sure that Air CD Pro is in standby. If it is powered on, press the Power button to put it in

standby.

2. Press and hold the Stop button. The Display will flash the currently selected time notation

setting (24-hour clock or 12-hour clock).

3. Use the Previous or Next button to select between a 24-hour clock (24) and a 12-hour clock

(12). When the setting you want is selected, press and release the Stop button to confirm your

selection. The Display will then show the time with the hours counter flashing.

4. Adjust the hours counter with the Previous and Next buttons. Once you’ve selected the correct

number of hours, press and release the Stop button to confirm your selection. The Display will

then show the time with the minutes counter flashing.

5. Adjust the minutes counter with the Previous and Next buttons. Once you’ve selected the

correct number of minutes, press and release the Stop button to confirm your selection. This

step will complete the process of setting the clock, and the Display will show the current time.

Note: When you disconnect Air CD Pro from power, the clock will reset.