iPA69C Quickstart Guide
Quickstart Guide (English) Introduction 1. Make sure all items listed in the Box Contents are included in the box. Look in the box under the foam sheet for the speaker stand rubber feet, speaker stand mounting knob, power cable, and microphone. 2. Read the safety instruction booklet before using the product. 3. Study the Connection Diagram. 4. Make sure all input devices such as microphones, CD players, or digital media players are turned off and volume settings are set at “zero.” 5.
Quick Setup Connection Diagram Items not listed under Introduction > Box Contents are sold separately. TOTAL PA GLOW USB drive SD Card Microphones Smartphone Power Tablet Speaker Stand Installation 1. Fully extend the speaker stand tripod legs on a flat, stable surface. Look in the box contents under the foam sheet for the rubber feet and speaker stand mounting knob. 1 2. Raise the mounting pole up to the appropriate height needed and tighten the side adjustment knob. 3.
Features Rear Panel 1. Media Panel: Controls for the USB, SD, FM radio (if applicable), and Bluetooth sources. The Media Panel Mode source symbol will illuminate when that source is playing. 2. USB Port: Connect your USB flash drive here to play music. 3. SD Card Slot: Insert your SD card here to play music. 4. Display: Displays the media panel modes for USB, SD, FM radio (if applicable), and Bluetooth. Note: The display comes with a plastic protector on it. Remove this for optimal viewing. 5.
16. Clip LED: This LED will flash red if the signal from the inputs or media panel source is clipping. If this happens, decrease the setting of the Mic Input Volume knob, Aux Input Volume knob, or Master Volume knob. 17. Power LED: Indicates whether Total PA Glow is powered on or off. 18. Light Mode Button: Press this button to select how the lights on the front panel function: • Color Cycle: The lights slowly glow and cycle through colors.
Media Panel Remote Note: Aim the remote straight at the front of the speaker woofer. Room lighting and battery life can affect the operating range of the remote control. Note: In order to use the remote control for the first time, first pull out the tab attached to the battery compartment. To change the remote battery, follow the diagram located on the back of the remote. Use a 3 V DC CR2032 lithium button cell battery for replacement. 1. Stop: Stops the media panel source from playing. 2.
Operation Pairing a Bluetooth Device 1. Turn on your Bluetooth device. 2. Power on Total PA Glow. 3. Use the Mode button to select Bluetooth mode, which appears as "bt" in the display. Total PA Glow will automatically go into pairing mode to search for Bluetooth devices. You will know you are in pairing mode when the Bluetooth icon is flashing. 4. Navigate to your Bluetooth device’s setup screen, find Total PA Glow, and connect. The Bluetooth icon will remain solidly lit.