HERE

ManualsBrandsiON Products ManualsPrimaryION 1/2 HP Cast Iron Stainless Steel Sump Pump w/ Adjustable Vertical Float (20' cord) HP20308

OPERATION MANUAL

BA PUMP SERIES

Thank you for purchasing a StormPro pump. Take the time to read the instructions carefully before using this appliance. We

strongly recommend that you keep this instruction manual in a safe place for future reference

SPECIFICATIONS

Output Discharge Rated Maximum

Model

(Hp) (Amp) (mm) (Inch) Head(ft) Flow(GPM) Head(ft) Flow(GPM)

Dimension

L x W x H

Weight

Lbs.

BA-33V/M 1/3 250 40 1-1/2" 10 50 25 68@0’ft 7.9” x 5.5” x 12.6” 13.5

BA-50V/M 1/2 400 50 2" 10 70 30 87@0’ft 9.1” x 6.3” x 13.8” 14.5

BA-75V/M 3/4 550 50 2" 10 84 35 97@0’ft 9.1” x 6.3” x 15” 22.5

• Check the nameplate for your pump's specification, refer to the table list.

• Be careful not to exceed the given specifications in the use of your pump.

MARKS AND MEANING:

DANGER

Keep the pump equipment out of the reach of children!

Warns that the failure to follow the directions given could cause serious risk to

individuals or objects.

WARNING

This sign warns the operator that the failure to follow an instruction may

damage the pump and/or the system.

LIMITATIONS:

This pump series is suitable to pump water and also can be used both for permanent and temporary installation.

The pump can be placed in a sump pit that means it could pump rain water containing suspended solid particles 6-10mm in

diameter.

WARNING

The pump can be used for sea water but not inflammable, corrosive, explosive or dangerous liquids.

Make sure that the pump never runs without liquids.

BA 33/50/75

Summary of content (4 pages)

PAGE 1
OPERATION MANUAL BA PUMP SERIES Thank you for purchasing a StormPro pump. Take the time to read the instructions carefully before using this appliance. We strongly recommend that you keep this instruction manual in a safe place for future reference SPECIFICATIONS Output (Hp) (Amp) 1/3 250 1/2 400 3/4 550 Model BA-33V/M BA-50V/M BA-75V/M • • Discharge (mm) (Inch) 40 1-1/2" 50 2" 50 2" Rated Maximum Dimension Weight L x W x H Lbs. Head(ft) Flow(GPM) Head(ft) Flow(GPM) 10 50 25 68@0’ft 7.9” x 5.5” x 12.
PAGE 2
INSTALLATION: Drill a 1/8”inch hole into PVC Pipe 4” inches above the pumps discharge. Do not work on pump until power is unplugged. Do not cut off ground pin or use an adapter fitting. Do not use an extension cord. The pump power cord should be connected to a separately fused, grounded line with a minimum capacity of 15 amps. It can be connected to non- fuse breaker as the recommended amperes. Never touch the pump when it is connected to electrical power. 1.
PAGE 3
TROUBLESHOOTING CHECKLIST PROBLEMS Pump does not run and hums POSSIBLE CAUSES ● ● ● ● ● ● ● ● Pump runs but does not deliver water. ● ● ● Pump runs and pumps out sump, but does not stop ● ● ● ● ● Pump runs but delivers only a small amount of water. ● ● ● Fuse blows or circuit breaker trips when pump starts. ● ● ● ● ● Motor runs for a short time, then stops. WARNING (CAUTION: SHUT OFF POWER TO PUMP) ● ● Line circuit breaker is off, or fuse is burned or loose.
PAGE 4
CONSTRUCTION AND PARTS LIST LIMITED WARRANTY This StormPro pump is warranted to be free from defects in material and workmanship and to perform within applicable specifications for a period of Two (2) years. Obligation under this warranty is limited to repairing or replacing any part thereof, which shall within two years be returned to us with transportation charges prepaid, and prove to be defective.