Product Manual

ManualsBrandsiON Products ManualsPrimaryION 1/2 HP Cast Iron Stainless Steel Sump Pump w/ Adjustable Vertical Float (20' cord) HP20308

StormPro

Series

Sump Pump

OPERATION MANUAL

Dated: 02/15/2013

Document Name: StormPro_BASeries_OM

Page 1 of 8

IntroductIon

Thank you for purchasing a StormPro

sump pump.

Take the time to read the instructions carefully before

using this appliance. We strongly recommend that

you keep this instruction manual in a safe place for

future reference.

Check the nameplate for your pump’s specication,

refer to the table list.

Be careful not to exceed the given specications in

the use of your pump.

Marks & MeanIngs

DANGER: Keep the pump equipment out of

the reach of children! Warns that the failure to

follow the directions given could cause serious risk to

individuals or objects.

WARNING: This sign warns the operator that

the failure to follow an instruction may damage

the pump and/or the system.

LIMItatIons

This pump series is suitable to pump water and also

can be used both for permanent and temporary

installation.

The pump can be placed in a sump pit that means

it could pump rain water containing suspended solid

particles no larger than ¼" in diameter.

Total Dynamic Head (Ft)

Capacity (GPM)

0 10 20 30 40 50 60 70 80 90

1/3HP

1/2HP

3/4HP

Model

Output

Discharge

(inch)

Rated Maximum

Dimensions

L x W x H

Weight

(lbs)

HP Amp Head (feet) Flow (GPM) Head Flow

BA33 1/3 4.5 1.5 10 50 0 GPM @ 25' 68 @ 0' 7-5/8 x 5-1/2 x 12-1/2" 16

BA50 1/2 5.8 2 10 61 0 GPM @ 29' 78 @ 0' 8-3/4 x 5-3/4 x 13-5/8" 24

BA75 3/4 7.5 2 10 74 0 GPM @ 37' 98 @ 0' 8-3/4 x 5-3/4 x 14-1/2" 25

Available Ion™ Switch, sufx i, or SPI switch, sufx spi, congurations. *Add 3-13/4" to width for Ion™ Switch.

Summary of content (8 pages)

PAGE 1
StormPro® BA Series OPERATION MANUAL Dated: 02/15/2013 Document Name: StormPro_BASeries_OM Page 1 of 8 Sump Pump Marks & Meanings DANGER: Keep the pump equipment out of the reach of children! Warns that the failure to follow the directions given could cause serious risk to individuals or objects. WARNING: This sign warns the operator that the failure to follow an instruction may damage the pump and/or the system.
PAGE 2
StormPro® BA Series Sump Pump WARNING: The pump can be used for sea water but not inflammable, corrosive, explosive or dangerous liquids. Installation Drill a 1/8″ inch hole into PVC pipe 4 inches above the pumps discharge. Do not work on pump until power is unplugged. Do not cut off ground pin or use an adapter fitting. Do not use an extension cord. OPERATION MANUAL Dated: 02/15/2013 Document Name: StormPro_BASeries_OM Page 2 of 8 6.
PAGE 3
StormPro® BA Series Sump Pump 11. Plug piggyback plug into a grounded outlet, then plug pump into the piggyback plug. See Figure 2. OPERATION MANUAL Dated: 02/15/2013 Document Name: StormPro_BASeries_OM Page 3 of 8 2. The plug and connections should be protected from water splashes. Before using the pump, always inspect it visually (especially power cable and plug). 3. Do not use the pump if it is damaged. 4. If the pump is damaged, have it inspected by an authorized service center only. 5.
PAGE 4
StormPro® BA Series Sump Pump OPERATION MANUAL Dated: 02/15/2013 Document Name: StormPro_BASeries_OM Page 4 of 8 B. If pump runs but does not deliver water, check the following: E. If fuse blows or circuit breaker trips, check the following: 1. Check valve is installed backwards. Arrow on valve should point in direction of flow. 1. Pump impeller is partially clogged, causing motor to run slow and overload. Remove pump and clean. 2. Discharge shut-off valve (if used) may be closed. 2.
PAGE 5
StormPro® BA Series Sump Pump Warranty VOID OPERATION MANUAL Dated: 02/15/2013 Document Name: StormPro_BASeries_OM Page 5 of 8 if... The following may cause severe damage to pump and will void the warranty: 1. Using an extension cord. 2. Power cord has been cut or altered. 3. Cutting off the ground pin or using an adapter fitting. 4. Working on pump or switch while plugged in. 5. Removing motor housing, unscrewing impeller, or otherwise removing impeller seal 6. Running the pump continuously. 7.
PAGE 6
StormPro® BA Series Sump Pump Notes Register your product at www.sumpro.
PAGE 7
StormPro® BA Series Sump Pump OPERATION MANUAL Dated: 02/15/2013 Document Name: StormPro_BASeries_OM Page 7 of 8 Notes Register your product at www.sumpro.
PAGE 8
StormPro® BA Series OPERATION MANUAL Dated: 02/15/2013 Document Name: StormPro_BASeries_OM Page 8 of 8 Sump Pump 3 Year Residential Warranty 1. Coverage and Term. Metropolitan Industries, Inc. (“Metropolitan”) warrants to the original purchaser (the “Buyer”) of each StormPro/Sumpro product (the “product”), that any part thereof which proves to be defective in material or workmanship within three (3) years from date of manufacture, will be replaced at no charge with a new or remanufactured part, F.O.B.