Product Manual

ManualsBrandsiON Products ManualsSewageION SHV40I+ - 1/2 HP Stainless Steel Sewage Pump (2") w/ ION Digital Level Control & High Water Alarm

Ion|StormPro

SHV40, 75 & 100

Sewage Ejector Pump

OPERATION MANUAL

Dated: 08/13/2013

Document Name: IonStormPro_SHV40-75-100_OM

Page 1 of 8

www.ionstormpro.com

Safety WarningS

Thank you for purchasing your Ion|StormPro

Pump.

To help ensure years of trouble-free operation, please

read the following manual carefully.

CAUTION: Read these safety warnings rst

before installing, servicing, or operating any

pump.

Before Installation

This manual contains important information for the

safe use of this product. Read this manual completely

and follow the instructions carefully. Reasonable care

and safe methods relating to the installation and

operation of this product should be practiced. Check

local codes and requirements before installation.

WARNING: Risk of Electrical Shock or

Electrocution. May result in serious injury or

death or re hazard. Installer must disconnect all

electrical sources prior to installation, handling or

servicing. Only qualied personnel may install this

system. NFPA 70/National Electric Code (NEC) or

local codes must be followed. System must be

properly grounded according to NEC. Do not lift pump

by power cord.

WARNING: Biohazard Risk. Once wastewater

source has been connected to system,

biohazard risk exists. Installer(s) and/or service

personnel must use proper Personal Protective

Equipment and follow handling procedures per OSHA

29 CFR 1910.1030 when handling equipment after

wastewater source has been connected to system.

WARNING: Risk of Asphyxiation. Installer(s)

and/or service personnel must use proper

Personal Protective Equipment and follow OSHA 29

CFR 1910.146 or OSHA 29 CFR 1926. Pump may be

installed in a location classied by as a conned

space.

WARNING: Risk of Fire or Explosion. Do not

smoke or use open ames in or around this

system. This system is not intended for use in

hazardous locations per NFPA 70 National Electric

Code. Do not pump ammable liquids. Consult factory

for optional equipment rated for hazardous location

use.

WARNING: Cutting Risk. Risk of serious

cutting or amputation exists. Disconnect all

power sources prior to servicing pump. Pump may

start without warning.

CAUTION: Do not modify the cord and plug.

When using the cord and plug, plug into a

grounded outlet only. When wiring to a system control,

connect the pump ground lead to the system ground.

CAUTION: Do not run the pump dry. Dry

running can overheat the pump (causing

burns to anyone handling it) and will void the warranty.

CAUTION: The pump normally runs hot. To

avoid burns, allow it to cool for 30 minutes

after shutdown before handling it.

Do not throw away or lose this manual. Keep it in a

safe place so that you may refer to it often for the

continued safe operation of the product.

These important instructions must be followed

for satisfactory performance of your pump.

Before installation, check your local electrical and

plumbing codes. Be careful not to exceed the given

specications in the use of your pump.

OvervieW

Summary of content (8 pages)

PAGE 1
Ion|StormPro® SHV40, 75 & 100 Sewage Ejector Pump OPERATION MANUAL Dated: 08/13/2013 Document Name: IonStormPro_SHV40-75-100_OM Page 1 of 8 biohazard risk exists. Installer(s) and/or service personnel must use proper Personal Protective Equipment and follow handling procedures per OSHA 29 CFR 1910.1030 when handling equipment after wastewater source has been connected to system. WARNING: Risk of Asphyxiation.
PAGE 2
Ion|StormPro® SHV40, 75 & 100 Sewage Ejector Pump OPERATION MANUAL Dated: 08/13/2013 Document Name: IonStormPro_SHV40-75-100_OM Page 2 of 8 Model Motor Info. Discharge Solids Handling GPM Rate @ 10 Ft Head Maximum Head Rating Maximum Flow Rating Dimensions (Inches) (L x W x H) Weight (Lbs) SHV40M-11 1/2 HP 115/1, 8.5 FLA 2" 2" 70 0 GPM @ 25’ 90 GPM @ 0' 9-1/8 x 5-1/2 x 16 31 SHV75M-11 3/4 HP 115/1, 11.
PAGE 3
Ion|StormPro® SHV40, 75 & 100 Sewage Ejector Pump e. Running the pump continuously. f. Pumping chemicals or corrosive liquids. g. Pumping gasoline or other flammable liquids. h. Piping, plastic PVC pipe could be installed in the outlet piping, but drain hose, galvanized steel or copper pipe may be used if desired. All piping must be clean and free of all foreign matter to prevent clogging. Use thread compound on all threaded joints unless specified otherwise.
PAGE 4
Ion|StormPro® SHV40, 75 & 100 Sewage Ejector Pump Pump runs and pumps out sump but does not stop 1. Float is stuck in up position. Be sure float operates freely in basin. 2. Defective float switch, replace. 3. Defective vertical switch, replace. Pump runs but delivers only a small amount of water 1. Pump is air-locked. Start and stop several times by plugging and unplugging cord. Check for clogged vent hole in pump case. Drill a 1/8″ inch hole into PVC pipe.
PAGE 5
® Ion® Digital Level Ion|StormPro SHV40, Control 75 & 100 Sewage Digital Level Ejector Control Pump Switch OPERATION MANUAL Dated: 08/13/2013 Document Name: IonStormPro_SHV40-75-100_OM IonDigitalLevelControl_OM Page 5 1 of 8 4 of the switch. From this point, measure up either 6” or 8.5”, depending on your switch’s range, to ﬁnd the On level. Please refer to the Installation Drawing. Patent pending CAUTION: Bottom of switch should not be mounted lower than suction inlet of pump.
PAGE 6
® Ion® Digital Level Ion|StormPro SHV40, Control 75 & 100 Sewage Digital Level Ejector Control Pump Switch Safety PreCautiOnS OPERATION MANUAL Dated: 08/13/2013 Document Name: IonStormPro_SHV40-75-100_OM IonDigitalLevelControl_OM Page 6 2 of 8 4 FIGURE B CAUTION: To prevent electric shock, ensure product is connected to a grounded outlet. The electrical outlet should be properly wired to a dedicated 15A circuit breaker.
PAGE 7
® Ion® Digital Level Ion|StormPro SHV40, Control 75 & 100 Sewage Digital Level Ejector Control Pump Switch trOubleShOOting Switch Does Not Turn On Pump 1. Test the pump without the Ion® switch a. Plug the pump directly into the wall outlet, without plugging it into the switch plug. b. If pump still does not run, see the troubleshooting section in the pump manual. c. If the pump does run, continue to the next step. 2. Test the switch with the pump a.
PAGE 8
® Ion® Digital Level Ion|StormPro SHV40, Control 75 & 100 Sewage Digital Level Ejector Control Pump Switch OPERATION MANUAL Dated: 08/13/2013 Document Name: IonStormPro_SHV40-75-100_OM IonDigitalLevelControl_OM Page 8 4 of 8 4 3 Year Residential Warranty 1. Coverage and Term. Metropolitan Industries, Inc.