Installation Manual

_____________________________________________________________________________________
303550 Installation Manual E-Series CMU Confidential
Revision Date: 14-Apr-2020 Revision: S
Process Owner: Engineering Page 24 of 36
1. Turn the CMU unit over and remove the T-20 Torx screws (ADS P/N 300842) that
hold the lid in place. See Figures below.
Figure E1
Figure E2
2. Carefully turn the unit over, being sure to hold the lid in place, as you do so.
3. Remove the lid, and set it aside. Inspect the enclosure and seal as directed by
Appendix F: Inspection of Equipment for Return to Service.
Note: Make sure the correct serial number sticker on lid stays with the correct
CMU board.
T20
Screws
(300842)
T20 Screws
(300842)