Installation Manual

_____________________________________________________________________________________
303550 Installation Manual E-Series CMU Confidential
Revision Date: 14-Apr-2020 Revision: S
Process Owner: Engineering Page 28 of 36
12. Tuck the power cable and NFC antenna wires into the case.
13. Place the lid on the base enclosure.
WARNING: ENSURE NO CABLES ARE PINCHED BETWEEN THE LID AND BASE WHEN
COVERING.
ATTENTION: ASSUREZ-VOUS QUE LES CÂBLES NE SONT PAS BRISÉS ENTRE LE COUVERCLE
ET LA BASE LORS DE LA COUVERTURE.
Figure E8
14. Inspect the enclosure and seal as directed by Appendix F: Inspection of Equipment
for Return to Service.
15. Press down on the lid around the edges to insure the O-Ring is fully seated.
16. Turn assembly over and attach the lid to the base using the T-20 torx screws that
were removed.
WARNING: SLOWLY TURN THE SCREWS COUNTER-CLOCKWISE UNTIL
YOU FEEL THEM CLICK INTO THE EXISTING THREAD BEFORE
TIGHTENING TO ENSURE HOLE IS NOT RE-THREADED. FAILURE TO DO
THIS WILL STRIP THE THREADS.
MISE EN GARDE: TOURNER LENTEMENT LES VIS DANS LE SENS
ANTIHORAIRE JUSQU'À CE QUE VOUS SENTEZ CLIQUER DANS LE FILET
EXISTANT AVANT DE LE SERRER POUR VOUS ASSURER QUE LE TROU
NE SOIT PAS RETIRÉ. LE FAIT DE NE PAS FAIRE CECI FERMERA LES
FILS.
17. Tighten screws to a torque of 2.5-2.7 N-m [22.0-24.0 in-lbs].