User Manual

31
Adjust the altitude and azimuth screws to move the read dot towards read cross. The image will be
enlarged when they are moving close.
When read dot fully covers red cross, the pole alignment is done.
NOTE: You can click on Settings and check RAW to see the real sky image at any time. Please
uncheck RAW during polar alignment for better results.
3. iPolar Calibration
If do not see the red cross on the screen, the iPolar has not been calibrated. Calibration is only
needed after iPolar is installed or any mechanical adjustment has been done on iPolar.
Rotate the RA axis of the mount roughly to the following three positions. Click on Confirm Position 1,
Confirm Position 2 and Confirm Position 3, respectively, to complete the calibration.