User guide

Page 2
INSTALLATION INSTRUCTIONS
CAUTION: Before installing, make certain the A.C. power is off and the ILB unit
connector is disconnected.
1. LED LIGHT
The ILB can be used with most LED loads that operate at 24VDC or 12VDC. See ILB Model
Specification Chart for output specifications of the unit being installed.
2. MOUNTING THE ILB
The ILB should be mounted on or nearby the fixture above the ceiling. The flex conduit marked “A” should be
wired into the driver/lamp compartment or to an electrical junction box on the fixture which allows access to the
fixture connections. Refer to Illustration 1 for typical mounting.
When battery packs are remote mounted, consult Customer Service for the maximum allowable distance between
the battery pack and the load.
3. WIRING
Refer to the wiring diagram on the back page for the appropriate wiring of the LED load and driver. Install in ac-
cordance with the National Electrical Code and local regulations. For additional wiring diagrams consult Cus-
tomer Service.
4. MOUNTING THE TBTS TEST ACCESSORY
Cut a single gang switch box into the ceiling tile adjacent to the fixture within reach of the ILB flex conduit marked
“B”. After mounting the switch box, connect flex to the box and route all leads inside the box. Refer to Illustration 1
for typical mounting.
Illustration 1 Downlight Fixture
FLEX “A”
JUNCTION
BOX
CEILING
TILE
A.C. BALLAST &
LAMP SOCKET COMPARTMENT
FLEX “B”
SWITCH BOX
TEST SWITCH
CHARGE LIGHT
ILB
TEST
ACCESSORIES
LED FIXTURE
ILB-1207
ILB-1212
ILB-2407
ILB-2412
12VDC
12VDC
24VDC
24VDC
7
12
7
12
*ALL VOLTAGES AND WATTAGES ARE NOMINAL
ILB MODEL SPECIFICATION CHART
TBTS