Data Sheet
Table Of Contents
- 1 Introduction
- 2 Summary
- 3 Block schematic
- 4 Development environment
- 5 Features
- 6 Pin assignment
- 7 Regulatory compliance
- 7.1 CE certification (Europe)
- 7.2 FCC (USA) and IC (Canada)
- 7.2.1 FCC Part 15 compliance statement
- 7.2.2 ISED - Industry Canada Licence-Exempt Radio Apparatus
- 7.2.3 ISED - Industrie Canada appareil radio exempts de licence
- 7.2.4 Radio Frequency (RF) Exposure Compliance of Radio communication for mobile Apparatus
- 7.2.5 Conformité à l’exposition aux champs RF des équipements radio mobiles
- 7.2.6 End Product Labeling
- 7.2.7 End Product User’s Manual:
- 8 Mechanical characteristics
2 0!
Changes or modifications not expressly approved by IOTIZE S.A.S. could void the user’s
authority to operate the equipment.
TapNLink TnL-FIW10x is tested and qualified under the following standards:
2 (- )-*
The TapNLink TnL-FIW10x operating range corresponds to:
o Frequency Band: 2402-2480MHz (BLE) / 2412-2472MHz (WIFI)
o Maximum Transmitting Power: Wi-fi 17.4mW and BLE 0.5mW (EIRP)
This device has been tested and certified for use in the European Union and IOTIZE hereby
declares that the device “TapNLink TnL-FIW10x” is in conformity with the essential
requirements of Directive RED 2014/53/EU. The complete Declaration of Conformity can be
found at:
o Appendix 1 of the present notice,
o www.iotize.com for the electronic version.
If this device is used in a product, the OEM is responsible for verifying compliance of the final
product with the relevant EU standards. A Declaration of Conformity must be issued and kept
on file. The ‘CE’ mark must be placed on the OEM product per the labeling requirements of the
Directive.
2 '(()7.*()(*
2 '((/&
2 -,(,-60.
This device contains licence-exempt transmitter(s)/receivers(s) that comply with Innovation,
Science and Economic Development Canda’s licence-exempt RSS(s). Operation is subject to
the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
TnL-FIW103 Datasheet 13
- This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
- This module has been approved under FCC part 15C 15.247. This modular transmitter is only
FCC authorized for this specific rule part.
- The module is limited to OEM installation ONLY.
- The OEM integrator is responsible for ensuring that the end-user has no manual instruction to
remove or install module.
- The host product manufacturer is responsible for compliance to any other FCC rules that
apply to the host not covered by the modular transmitter grant of certification. (For example,
Part 15 Subpart B)
- If testing of the host product with this transmitter installed and operating is necessary (to verify
that the host product meets all the applicable FCC rules), a test mode for this specific module is
available upon request to IOTIZE.
- Trace antenna design, list of antenna type approved and professional installation is not
applicable to this modular certification.