User's Manual

Proprietary & Confidential Information
iotTech Corporation, Taiwan
Doc. NO:
ITM-FCC3F1 Datasheet
8.Appendix
Compliance with
2.2 List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C has investigated. It is applicable to the modular transmitter.
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting condition
or different operational conditions (example, uses another antenna) for a stand-alone modular transmitter in a host, host
manufacturer have to consult with module manufacturer for the installation method in end system.
2.4 Limited module procedures
This module is single modular.
Not applicable.
2.5 Trace antenna designs
Not applicable.
2.6 RF exposure considerations
This modular transmitter should be used in the mobile conditions and 0.5cm from a person’s body, the host product
manufacture should be put those information in the end-product manual to the end users. If RF exposure statement and
use conditions are not provided, then the host product manufacture is required to take responsibility of the module
through a change in FCC ID(new application)
2.7 Antennas
This radio transmitter FCC ID : 2A263ITM-FCC3F1 has been approved by Federal Communications Commission
to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not
included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited
for use with this device.
Manufacturer
Part No.
Antenna Type
Maximum antenna gain
IOTTECH
ITM-FCC3F1
PCB Antenna
1.376dBi for 2.4GHz
-1.840dBi for 5.150-5.250 GHz
0.745dBi for 5.725~5.825GHz
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID: 2A263ITM-FCC3F1
".
2.9 Information on test modes and additional testing requirements
Host manufacturer which install this modular with modular approval should perform the test of radiated emission and
spurious emission according to FCC part 15 :15.212 requirement, only if the test result comply with FCC part 15.212
requirement, then the host can be sold legally.
When testing host product, the host manufacture should follow FCC KDB Publication 996369 D01 Module Integration
Guide for testing the host products. The host manufacturer may operate their product during the measurements.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all other applicable
requirements for the system such as Part 15 B.