User's Manual

nano3G AP Installation Manual nano3G AP Hardware Installation
N3G_INST_300 v6.3 for N3G_2.0 © ip.access Limited 2010 Page 14
3 nano3G AP Hardware Installation
This section documents the procedure used to install the nano3G AP hardware and
physical connections together with applying the base software configuration.
Note: If possible, the engineer should stay on site until the AP is brought into service, ready to
make test calls to verify the AP has been configured correctly from the OMC-R.
3.1 Warnings and Regulatory Information
For all warnings and regulatory information, see section 8.
3.2 Hardware Installation - nano3G S4 AP
3.2.1 Unpack the nano3G S4 AP
1) Unpack the nano3G S4 AP and its accessories.
Box contents may vary, but typically the box should contain the following, as
pictured:
Upper layer:
• nano3G S4 AP unit
• nano3G S4 AP stand
Lower layer:
• POE injector unit
• POE splitter unit
• Mains adaptor unit
• Mains cable for POE
injector