User's Manual

nano3G AP Installation Manual nano3G AP Hardware Installation
N3G_INST_300 v6.3 for N3G_2.0 © ip.access Limited 2010 Page 23
POE+ Switch
In this case, the POE+ switch is a third-party item. The cable run from the switch to the AP
can be a full 100m.
A POE+ switch will typically only be used if there are multiple APs on site and/or there is
other equipment that can take advantage of POE+.
PSU and LAN
When a suitable PSU is used to power the AP (see section 2.4.1) the POE+ injector unit is
not needed. However, this means that a mains socket providing power to the AP must be
within reach of the cabling included with the PSU. This is typically less than 2m. The PSU
for the E8 AP is an optional extra.
3.3.6 Mount the nano3G E8 AP on a Wall
Note: The nano3G E8 AP should be installed in a position so that it is at least 2m away from the
area where handsets are normally used.
The nano3G E8 AP must be mounted vertically to ensure air circulation around the unit.
The location of each nano3G E8 AP is shown on the installation floor plan produced at the
network planning stage. For example, it must take into account that all APs must be at least
2m from any mobile equipment. The network wiring must be complete before the nano3G
E8 AP can be installed and commissioned. The nano3G E8 AP should be placed on a wall
at or above head height.