User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 nano3G AP Hardware Installation
- 4 Commission a nano3G AP
- 5 Configuration File Preparation
- 6 Configuring a nano3G AP from the OMC-R
- 7 Troubleshooting
- 8 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Commission a nano3G AP
N3G_INST_300 v6.3 for N3G_2.0 © ip.access Limited 2010 Page 28
4.2 Configure the AP-AC Connection
12) Power up the AP.
For the nano3G S4 AP, either:
• Use the power supply provided with the AP
or
• Connect the short power cable from the POE Splitter unit - this will also
require power into the splitter unit from a POE source
For the nano3G E8 AP, typically do one of the following:
• Connect the laptop to the LAN input on the POE+ injector unit, connect a
cable to carry POE+ from the injector to the LAN1 port on the AP, then plug
the POE+ injector into the mains
or
• Connect the optional power supply for the AP to the AP’s 12V DC input, and
connect the laptop to the LAN1 port on the AP
13) Start a web browser on the laptop.
14) In the address bar, enter the pre-defined static IP address and port number for the
web server: http://192.168.0.1:8089. A login screen appears.
15) Enter the commissioning user name and the password (supplied separately for
security reasons). The Connection Config page appears: