User's Manual

nano3G AP Installation Manual Commission a nano3G AP
N3G_INST_300 v6.3 for N3G_2.0 © ip.access Limited 2010 Page 29
4.2.1 Static IP Configuration
Obtaining an IP address with DHCP is recommended for the nano3G AP, and this is
selected by default. Only execute this section if static IP configuration is needed. This
must be done before completing the Connection Config page.
16) If static IP is required, click the IP Config link on the left. The IP Configuration page
appears.
17) Edit the parameters as needed and then click Apply.
Note: At this point it may be useful to make a separate note of the parameter
values entered in this screen. Alternatively, save a screenshot of the web
page (information about how to take a screenshot is outside the scope of
this manual).
18) Click the Connection Config link on the left.
4.2.2 Configure the AC Connection
19) If Secure Connection is required, select IPSec Enabled, and enter the IPSec
Gateway and Traffic Selector addresses.
20) Enter the IP address of the AC and the NTP server (do not use the values shown -
these are examples only).
21) Enter the ID of the AP. This must be the same as the Cell ID assigned to the AP.
22) To save the configuration, click Apply Changes.