User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 nano3G AP Hardware Installation
- 4 Commission a nano3G AP
- 5 Configuration File Preparation
- 6 Configuring a nano3G AP from the OMC-R
- 7 Troubleshooting
- 8 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Configuration File Preparation
N3G_INST_300 v6.3 for N3G_2.0 © ip.access Limited 2010 Page 37
staticGsmNeighbourList This is a complex attribute that specifies GSM (2G) neighbour
candidates. It is recommended to enter these directly in the OMC-
R Client. However, if a similar list has already been configured for
a nearby AP, it may be advantageous to copy this attribute from a
configuration file saved from the nearby AP, load this into the
target AP and then make suitable adjustments from the OMC-R
Client.
See [OPM_300] for information on neighbour list configuration.
staticUmtsNeighbourList This is a complex attribute that specifies UMTS (3G) neighbour
candidates. It is recommended to enter these directly in the OMC-
R Client. However, if a similar list has already been configured for
a nearby AP, it may be advantageous to copy this attribute from a
configuration file saved from the nearby AP, load this into the
target AP and then make suitable adjustments from the OMC-R
Client.
See [OPM_300] for information on neighbour list configuration.
Oscillator Synchronisation Package
oscillatorSynchronisationTim
eout
The number of days an AP can go without resynchronisation
before it raises the relevant alarm.
Parameter Description