User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 nano3G AP Hardware Installation
- 4 Commission a nano3G AP
- 5 Configuration File Preparation
- 6 Configuring a nano3G AP from the OMC-R
- 7 Troubleshooting
- 8 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Troubleshooting
N3G_INST_300 v6.3 for N3G_2.0 © ip.access Limited 2010 Page 44
7.3.2 nano3G E8 AP Factory Reset
To perform a factory reset, press and hold the reset button for more than 5 seconds.
The 3G LED will blink fast (50ms on, 50ms off) for 5 seconds, then it will start to blink slowly
(200ms on, 200ms off). When the factory restore process has completed, the LED will
extinguish and the AP will automatically reboot, take the fixed IP address and enable the
web interface for configuration (see section 4).
7.4 nano3G E8 AP Does Not Start Up
• Check the power-over-Ethernet inserter: it must be a POE+ unit
• Verify the Ethernet cable from the POE+ inserter is plugged into the correct socket
(LAN1)
• If using a DC power supply instead of POE+, verify the power supply is a 12V
supply with the correct polarity