Installation Guide
Table Of Contents
- nano3GAP Installation Manual
- 1 Introduction
- 2 Installation Requirements
- 3 nano3GAP Hardware Installation
- 4 Deployment Commissioning of the nano3GAP
- 5 Configuration of the nano3GAP-4 from the OMC-R
- 6 Troubleshooting
- 7 nano3GAP and PSU Regulatory Information
- 8 Appendices
- 8.1 Appendix A - Example AP Configuration File
- 8.2 Appendix B - Licenses and Copyright Notices
- 8.2.1 asn1c
- 8.2.2 bash
- 8.2.3 BusyBox
- 8.2.4 cramfs
- 8.2.5 dropbear
- 8.2.6 glibc
- 8.2.7 gmp
- 8.2.8 ipkg
- 8.2.9 iproute2
- 8.2.10 iptables
- 8.2.11 libcurl
- 8.2.12 libgcc
- 8.2.13 libpcap
- 8.2.14 libxml2
- 8.2.15 Linux Kernel
- 8.2.16 mtd.utils
- 8.2.17 ncurses
- 8.2.18 NTP daemon
- 8.2.19 pcre
- 8.2.20 procps
- 8.2.21 SSL Stack
- 8.2.22 StrongSwan
- 8.2.23 TCL
- 8.2.24 tcpdump
- 8.2.25 thttpd
- 8.2.26 U-Boot
- 8.2.27 zlib
- 8.2.28 General Licenses
nano3GAP Installation Manual nano3GAP and PSU Regulatory Information
© ip.access Ltd Page 21
7 nano3GAP and PSU Regulatory Information
This chapter provides the customer with safety and regulatory warnings, cautions and
information for the ip.access Ltd range of products.
7.1 Warnings and Cautions
Electrical Safety
CAUTION
The nano3GAP-4 is intended for dry indoor applications only. If evidence of
condensation is present do not apply power to the nano3GAP-4.
WARNING
Do not immerse any part of the nano3GAP-4 or its power supply in water or any
other liquid. Do not install or use the nano3GAP-4 or its power supply near open
water. Do not spill liquids of any type on the nano3GAP-4 or its power supply.
WARNING
Do not use liquid, solvent or aerosol cleaning agents on or near the nano3GAP-
4 or its power supply.
CAUTION
To avoid the risk of fire and/or electrical shock, do not push objects through
openings into the nano3GAP-4 or its power supply (except when operating the
Reset switch on the nano3GAP-4).
CAUTION
Do not disassemble the nano3GAP-4 or its power supply.
CAUTION
The nano3GAP-4 must only be powered using the ip.access power supply
provided for use with the nano3GAP-4.
CAUTION
Before using the power supply, verify that the mains voltage is within the range
specified by the voltage printed on the power supply.
CAUTION
The PSU supplied with the nano3GAP-4 must not be used for powering any
other equipment.
CAUTION
To avoid the risk of fire and/or electrical shock, do not overload power outlets or
extension cables.
CAUTION
When disconnecting the power supply from the mains, pull the plug. Pulling the
cable may result in damage to the cable.