Installation Instructions

nano3G AP Installation Manual Installation Overview and Requirements
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 6
The following ports are also used. When IPsec is used, they may be inside or outside the
IPSec tunnel, depending on configuration:
2.2.2 Information Required for Pre-Provisioning
All nano3G AP models require the configuration details listed in this section. This
information will be used to configure an AP from the OMC-R Client, typically by a NOC
engineer.
• User name and password for the OMC-R Client. To be able to configure an AP
from the OMC-R Client, the user name must have Full Access to the AP
Management System serving the AP and Full Access granted to its APs. See
[OPM_410] for full details about user permissions.
• The minimum set of configuration data for the AP is:
• Cell ID (also used as the ID of this AP on the serving nano3G AC)
• IP Address or FQDN of the serving AC
• MCC
•MNC
•LAC
•RAC
•SAI SAC
•SAI LAC
•UARFCN
• Scrambling code
• RNC ID
• RSSI scan bands
• Latitude and longitude of the APs installation site, for RANAP location
reporting
• Additional configuration that may be required includes:
• Static neighbour list - see [OPM_300] for neighbour list configuration
• URLs for the PM reporting and diagnostic services on the AP Management
System
Note: It is possible to configure an AP before taking it on site.
Protocol Destination Port Use
tcp 80 PM upload, software download, CRL download
tcp 443 PM upload, software download, CRL download
udp 53 DNS
udp 67 DHCP - not needed for static IP configuration
udp 68 DHCP - not needed for static IP configuration
udp 123 NTP