Installation Instructions

nano3G AP Installation Manual Pre-Provisioning a nano3G AP
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 25
3.2 Apply an Attribute Configuration to the AP
This is optional. This could be done if, for example:
• No AP or configuration file was used as the basis for the AP’s initial configuration
• There is a requirement to load multiple configuration files
For information on preparing an AP configuration file, see section 4.
1) Ensure the attribute configuration file is available on the OMC-R Server or the
computer running the OMC-R Client.
2) Log in to the OMC-R Client with a user name that has Full Access to the AP.
3) To start the OMC-R Load Attributes Wizard, right-click on the AP object in the
OMC-R Client and then select Load Attributes From File.
4) Browse to the edited configuration file and click Apply to load and apply the
configuration settings.
If any of the loaded values are inconsistent with the current state of the AP or if any
of the values are illegal, the wizard displays a warning.
5) Repeat as needed, if there are multiple configuration files.