Installation Instructions

Table Of Contents

nano3G AP Installation Manual Configuration File Preparation

N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 30

4.3.2 Example AP-Specific Configuration File

The following example file shows the attributes that are unique for each AP. This is a

manually created example, rather than being based on a file exported from an existing AP.

Object=apNano8_020

# Network Listen Control Package

lacRacCandidateList=({15912,(99)})

rfParamsCandidateList=({1062,437,1})

rfScanControl={"0200",1440,240,true}

# Location Package

lcsLongitude=-2540

lcsLatitude=695

lcsUncertainty=15

# end of file

neighbourListPopulation This determines how the live neighbour list is populated. The

recommended setting is STATIC_ONLY, which only uses

neighbours entered in the static neighbour lists, as determined

by network planning.

diagnosticReporting for S4 APs

or diagnosticReporting_001 for

E8 APs

Set the URL of the AP Management System diagnostics service.

Replace oam.server with the IP address or FQDN of the server.

reportingUrl Set the URL of the AP Management System measurement

reporting service. Replace oam.server with the IP address or

FQDN of the server.

localTimeZone Set the timezone, in POSIX format, where the APs are located.

This assumes that all APs on the same AC are in the same

timezone, which is the most probable scenario. If APs are spread

across several timezones, this can be an AP-specific setting.

Parameter Description

Object Object type for APs, must be apNano_002 or apNano8_001

lacRacCandidateList LAC and RAC for the AP.

rfParamsCandidateList Set the UARFCN, Scrambling Code and Cell ID to be used by the

AP.