Installation Instructions

Table Of Contents

nano3G AP Installation Manual Configuration File Preparation

N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 31

4.3.3 Other Attributes

The following table shows some other attributes to consider for inclusion in AP configuration

files. Apart from the static neighbour lists, which are usually configured individually, any of

these can be in a general template for all APs or can be set individually.

rfScanControl This is composed of:

• The scan time, as HHMM, for the first scan, after which

the scans take place every time the interval passes - if

this is daily, set the time when usage is expected to be

low so that the NWL scan does not disrupt the service

• The interval in minutes, the default value of 1440 is one

day, or set to 0 to disable periodic scans

• The randomization period in minutes, which ensures

multiple APs in close proximity do their scans at different

times

• Use reduced scan, true or false: a reduced scan is faster

but may not detect all changes to the RF environment

Note: Depending on deployment requirements, this could be in the

general template instead.

lcsLongitude This is entered as a number for east (positive) or west (negative) of

the Greenwich meridian. It may be easier to enter this directly in

the OMC-R Client, as this allows entry in degrees, minutes and

seconds.

lcsLatitude This is entered as a number for north (positive) or south (negative)

of the equator. It may be easier to enter this directly in the OMC-R

Client, as this allows entry in degrees, minutes and seconds.

lcsUncertainty Radius of uncertainty in metres.

Parameter Description

Admission Control Package

psHandoverEnabled Whether or not PS RABs will handover between an AP and the

macro network. This is disabled (false) by default.

Network Listen Control Package

neighbourPlmns If specified, this restricts the networks that neighbouring cells can

belong to for populating the neighbour lists by specifying the

MCC/MNC values.

plmnsToSyncWith If specified, this restricts the networks that neighbouring cells can

belong to for frequency synchronisation by specifying the

MCC/MNC values.