Installation Instructions
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Configuration File Preparation
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 32
staticGsmNeighbourList This is a complex attribute that specifies GSM (2G) neighbour
candidates. It is recommended to enter these directly in the
OMC-R Client. However, if a similar list has already been
configured for a nearby AP, it may be advantageous to copy this
attribute from a configuration file saved from the nearby AP, load
this into the target AP and then make suitable adjustments from
the OMC-R Client.
See [OPM_300] for information on neighbour list configuration.
staticUmtsNeighbourList This is a complex attribute that specifies UMTS (3G) neighbour
candidates. It is recommended to enter these directly in the
OMC-R Client. However, if a similar list has already been
configured for a nearby AP, it may be advantageous to copy this
attribute from a configuration file saved from the nearby AP, load
this into the target AP and then make suitable adjustments from
the OMC-R Client.
See [OPM_300] for information on neighbour list configuration.
Oscillator Synchronisation Package
oscillatorSynchronisationTim
eout
The number of days an AP can go without resynchronisation
before it raises the relevant alarm.
Parameter Description