Installation Instructions

nano3G AP Installation Manual Commission a nano3G AP
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 37
8) Click Swap Banks. This will restart the AP from the new software just downloaded.
9) When the AP has restarted, login again with the commissioning user name and
password.
10) Click the SW Download link on the left.
11) Inspect the software version information to verify that the AP has booted from the
downloaded software.
5.4.2 Optional - ATAS Download
Use the ATAS Download page to download a package of security certificates that are
appropriate for the AP’s target network. This is not necessary if the AP is factory installed
with the correct certificates.
12) Click the ATAS Download link on the left. The web page for downloading an ATAS
bundle will be shown. This will also show any current ATAS version information, if
applicable.
13) In the text box, enter the URL for the SPD file stored on the commissioning
terminal, which contains the required ATAS bundle. For example:
http://192.168.0.2/webservername/atas_file.spd
14) Click Begin Download.
15) Wait about a minute.
16) Click Extract Previously Downloaded ATAS.
17) Wait about a minute. If the ATAS version information is not refreshed, use the
appropriate browser command to refresh the web page.
18) Inspect the ATAS version information to verify it is correct.