Installation Instructions

nano3G AP Installation Manual Commission a nano3G AP
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 39
5.5.2 Configure the AP Management System Connection
22) If a secure connection is required, select IPSec Enabled. Also enter the address
for the IPSec Gateway and the Traffic Selector address and subnet mask.
23) Enter addresses for the AP Management System, a suitable CRL server and the
NTP server.
24) To save the configuration, click Apply Changes.
Note: At this point it may be useful to make a separate note of the parameter
values entered in this screen. Alternatively, save a screenshot of the web
page (information about how to take a screenshot is outside the scope of
this manual).
5.5.3 Complete the AP Commissioning
25) Click the Connection Config link on the left, to ensure the correct page is
showing.
26) To start the AP in normal operation mode, click Complete Commissioning.
27) Acknowledge the warning about changes in the IP configuration and click OK.
28) When the initial configuration is complete, power off the AP and disconnect it from
the commissioning terminal.
At this point, the commissioning web page is no longer accessible. If there are
configuration errors that prevent the AP connecting to its serving AP Management
System, the commissioning procedure must be started again after resetting the AP
with a factory reset. See section 8.2 for factory reset instructions.