Installation Instructions
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual nano3G AP Hardware Installation
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 48
6.3 nano3G S8 AP Hardware Installation
6.3.1 Unpack the nano3G S8 AP
1) Unpack the nano3G S8 AP and its accessories.
Box contents may vary, but typically the box should contain the following:
• nano3G S8 AP unit
• nano3G S8 AP stand
Plus any combination of the following items, according to the options ordered:
• Mains adaptor unit
• POE injector unit and suitable mains cable
• POE splitter unit
Note: No screws are supplied to mount the AP or the splitter unit.
2) Check that the serial number on the nano3G S8 AP unit matches the label on the
box.
3) Check that the items have not been damaged in transit.
For any damaged units, contact the supplier immediately for returns advice.