Installation Instructions

nano3G AP Installation Manual Introduction
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 1
1 Introduction
The ip.access nano3G AP is an indoor Access Point for enterprise applications.
This manual provides all the necessary information required to install an ip.access nano3G
AP. The manual provides step-by-step instructions for hardware installation and
configuration steps required to bring a nano3G AP into service.
The AP can be configured with a static IP address or it can obtain an IP address
dynamically via DHCP. The AP-AC connection can be configured to be secure (via IPSec
and a security gateway) or unsecured.
1.1 Overview
This manual is organised as follows:
• AP installation requirements
• AP configuration preparation
• AP hardware installation
• Commissioning configuration, for initial connection to an AC
• Configuration from the OMC-R
• Installation troubleshooting
• Regulatory warnings and safety information
• Supplementary information on licensing
1.2 User Requirements
It is assumed that any readers that will use the OMC-R Client already know how to:
• Start the OMC-R Client
• Navigate the Explorer Pane to find an AP object
Refer to [OPM_410] for information on using the OMC-R Client.