Installation Instructions

nano3G AP Installation Manual Troubleshooting
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 67
8.1.2 nano3G E8 AP LEDs
The following table shows the meaning of the status indicators under normal and fault
conditions.
3G Off The nano3G E8 AP is not provisioned, it has no IP address. This
may be a temporary condition when the AP is switched on for the
first time, or after factory reset.
Green The nano3G E8 AP is provisioned and unlocked, it is connected to
the AC and is providing service.
Flashing green
(evenly, slowly)
The nano3G E8 AP is provisioned but has lost connection to the AC,
for example because the AC is not available or there is a DNS
problem.
The nano3G E8 AP is locked.
Flashing green
(evenly, fast)
The nano3G E8 AP has been reinitialized (the reset button was
pressed but for less than 5 seconds).
Off, with short
green blinks on
Factory reset is in progress in the nano3G E8 AP (the reset button
was pressed for more than 5 seconds).
On, with short
green blinks off
Software download is in progress to the nano3G E8 AP.
Power Off The nano3G E8 AP is not switched on.
Green The nano3G E8 AP is powered up normally.
Flashing green Self-test is running.
Red There is a fault with the nano3G E8 AP.
Ethernet
Link
Amber This is on to show the link is active, or flashes when there is network
activity.
Ethernet
Speed
Green Shows the network speed. On for 100Mbps or off for 10Mbps.