Installation Instructions
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Troubleshooting
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 68
8.2 Backhaul Network Connection Problems
If static IP addressing is disabled and DHCP is in use, the nano3G AP expects to be
automatically provided with an IP address by the broadband router every time it starts.
Ensure that the DHCP service is enabled on the broadband router.
8.3 nano3G E8 AP Does Not Start Up
Check the following:
• Check the power-over-Ethernet inserter: it must be a POE+ unit.
• Verify the Ethernet cable from the POE+ inserter is plugged into the correct socket
(LAN1).
• If using a DC power supply instead of POE+, verify the power supply is a 12V
supply with the correct polarity.