Installation Instructions

nano3G AP Installation Manual nano3G AP and PSU Regulatory Information
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 71
9 nano3G AP and PSU Regulatory Information
This chapter provides the customer with safety and regulatory warnings, cautions and
information for the ip.access Ltd range of products.
9.1 Warnings and Cautions
Electrical Safety
CAUTION
The nano3G AP is intended for dry indoor applications only. If evidence of
condensation is present do not apply power to the nano3G AP.
CAUTION
The nano3G AP is designed to be operated as a fixed system device and must be
located away from the user. It must be mounted in a manner to ensure that all
users and bystanders are kept a minimum of 20cm away from the integral
antennas at all times.
WARNING
Do not immerse any part of the nano3G AP or its power supply in water or any
other liquid. Do not install or use the nano3G AP or its power supply near open
water. Do not spill liquids of any type on the nano3G AP or its power supply.
WARNING
Do not use liquid, solvent or aerosol cleaning agents on or near the nano3G AP or
its power supply.
CAUTION
To avoid the risk of fire and/or electrical shock, do not push objects through
openings into the nano3G AP or its power supply (except when operating the
Reset switch on the nano3G AP).
CAUTION
Do not disassemble the nano3G AP or its power supply.
CAUTION
The nano3G AP must only be powered using the ip.access power supply provided
for use with the nano3G AP.
CAUTION
Before using the power supply, verify that the mains voltage is within the range
specified by the voltage printed on the power supply.
CAUTION
The PSU supplied with the nano3G AP must not be used for powering any other
equipment.
CAUTION
To avoid the risk of fire and/or electrical shock, do not overload power outlets or
extension cables.
CAUTION
When disconnecting the power supply from the mains, pull the plug. Pulling the
cable may result in damage to the cable.