Installation Instructions
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual nano3G AP and PSU Regulatory Information
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 76
9.4 Regulatory Statements for nano3G E8 AP
9.4.1 US FCC Compliance
• FCC CFR47 Parts 15B, 27
Note: Changes or modifications not expressly approved by the party responsible for compliance
may void the user's authority to operate this equipment.
Model nano3G 217C has FCC ID QGGIPA217C
Note: This equipment has been tested and found to comply with the limits for a class A digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
9.4.2 EU Regulatory Compliance
Model nano3G 217A conforms to the following regulatory standards:
"Hereby, ip.access Ltd, declares that this nano3G S4 AP is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC."
A copy of regulatory compliance documentation may be obtained in writing from "IP Access
Ltd, Building 2020, Cambourne Business Park, Cambourne, Cambridge, CB23 6DW, UK".
9.4.3 Safety Standards
• IEC 60950-1:2005 (2nd Edition) and EN 60950-1:2006
WARNING
This is a class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
Health (Art 3.1(a)): EN50385: 2002
Safety (Art 3.1(a)): EN60950-1: 2006
EMC (Art 3.1(b)): EN 301 489-23 V1.3.1, EN 302 489-1 V1.8.1
Spectrum (Art 3.2): EN 301 908-1 V4.2.1, EN 301 908-3 V3.2.1
This product is intended for use in all
Member States of the European Union.