Installation Instructions
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Installation Overview and Requirements
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 4
• If there is a commissioning error, this can be corrected immediately without
needing to return the AP
• If an AP has been in storage for some time, the required software build and/or
ATAS package can be installed on the AP in situ
2.1.3 On Site Installation
Physical installation of a nano3G AP at its operating site, including providing the AP with
power and a suitable network connection that provides a backhaul path to the AP
Management System and AC.
If a nano3G AP has been enabled for service prior to the site visit, the installation engineer
can make test calls immediately.