User's Manual

nano3G AP Installation Manual Installation Overview and Requirements
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 7
2.2.2 nano3G AP Cooling
Special attention must be given to ensure a nano3G AP will meet its air cooling
requirements in its installed location.
Take the following points into consideration for the physical location of an AP:
• All AP models must be installed so that they are upright, to ensure proper air will
flow through the body of the AP to provide cooling.
• All AP models must not be installed in enclosed spaces where air flow is
restricted. This includes, but is not necessarily limited to:
• Roof or ceiling spaces
• Small cabinets
• Tightly enclosed shelf spaces
• When free-standing the nano3G S8 AP, the stand supplied for this purpose must
be used, and the AP must be upright, as noted above.
2.2.3 Information Required for Pre-Provisioning
This information will be used to configure an AP from the NOS Client. The parameters
depend on the deployment scenarios:
• Parameters for Enterprise Deployments
• Parameters for Residential Deployments
Note: It is recommended to pre-provision an AP before taking it on site, so that the AP can
download its configuration when it starts up on site.
OMC-R Client Login Details
User name and password for the NOS Client. To be able to configure an AP from the NOS
Client, the user name must have Full Access to the NOS Server serving the AP and Full
Access granted to its APs. See [OPM_415] for full details about user permissions.