User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 2.1 Installation Tasks
- 2.2 Requirements for All nano3G APs
- 2.2.1 General Requirements
- 2.2.2 nano3G AP Cooling
- 2.2.3 Information Required for Pre-Provisioning
- 2.2.4 Parameters for Enterprise Deployments
- 2.2.5 Parameters for Residential Deployments
- 2.2.6 Access Control
- 2.2.7 Closed Access with CSG Parameter Broadcast
- 2.2.8 Closed Access in Legacy Mode
- 2.2.9 Pre-Prepared Configurations - Optional
- 2.2.10 Information Required for Commissioning
- 2.2.11 Other Items for Commissioning
- 2.3 nano3G S8 AP Site Requirements
- 2.4 nano3G S16 AP Site Requirements
- 2.5 nano3G E8 AP and nano3G E16 AP Site Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Installation Overview and Requirements
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 17
2.2.9 Pre-Prepared Configurations - Optional
The options described here can be used independently or in any combination.
Use an Existing AP
The Create Site Wizard, which is used for the initial pre-provisioning of an AP, allows
selection of an existing AP as the basis for configuring the new AP. This is a one-time
option that is only available in the Create Site Wizard.
Configuration Files
An initial configuration file can be used to rapidly configure the AP via the NOS Create Site
Wizard. This is can be an alternative or in addition to using settings from an existing AP or
using a template. Additional configuration files can be loaded against the AP object after it
has been created by the Create Site Wizard. If they will be used, the location of any
configuration files must be known.
Configuration files are described in section 4.
AP Templates
As with configuration files, an initial AP template can be used to rapidly configure the AP via
the NOS Create Site Wizard. This can be an alternative to or in addition to using settings
from an existing AP or using a configuration file. Additional templates can be applied
against the AP object after it has been created by the Create Site Wizard.
For information on working with templates, see [OPM_415].