User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 2.1 Installation Tasks
- 2.2 Requirements for All nano3G APs
- 2.2.1 General Requirements
- 2.2.2 nano3G AP Cooling
- 2.2.3 Information Required for Pre-Provisioning
- 2.2.4 Parameters for Enterprise Deployments
- 2.2.5 Parameters for Residential Deployments
- 2.2.6 Access Control
- 2.2.7 Closed Access with CSG Parameter Broadcast
- 2.2.8 Closed Access in Legacy Mode
- 2.2.9 Pre-Prepared Configurations - Optional
- 2.2.10 Information Required for Commissioning
- 2.2.11 Other Items for Commissioning
- 2.3 nano3G S8 AP Site Requirements
- 2.4 nano3G S16 AP Site Requirements
- 2.5 nano3G E8 AP and nano3G E16 AP Site Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Pre-Provisioning a nano3G AP
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 32
4) Select the Object Class radio button and in the drop-down list on the left and select
one of the following: This is applicable to E8 APs, E16 APs and S8 APs.
• Nano-8 or Nano-16 3G AP (SR2.0 -). This applies to N3G_2.83 AP
software.
• Nano 3G AP (SR2.4 -). This applies to N3G_2.85 or later AP software.
Note: Do not select Nano-4 3G AP (SR2.0 -) as this is not supported in
N3G_2.92.
Note: If they are present, do not choose either of the choices for (SR1.2 -
PRE-SR2.0). These are only used for APs running software from a
release prior to N3G_2.92. These choices must be present for backwards
compatibility and they enable AP upgrades from previous releases.
3.2.2 Optional - Use an Existing AP Configuration
5) Click Next and the AP Selection page of the wizard will appear:
Optionally use this page to copy the configuration of an existing AP.