User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 2.1 Installation Tasks
- 2.2 Requirements for All nano3G APs
- 2.2.1 General Requirements
- 2.2.2 nano3G AP Cooling
- 2.2.3 Information Required for Pre-Provisioning
- 2.2.4 Parameters for Enterprise Deployments
- 2.2.5 Parameters for Residential Deployments
- 2.2.6 Access Control
- 2.2.7 Closed Access with CSG Parameter Broadcast
- 2.2.8 Closed Access in Legacy Mode
- 2.2.9 Pre-Prepared Configurations - Optional
- 2.2.10 Information Required for Commissioning
- 2.2.11 Other Items for Commissioning
- 2.3 nano3G S8 AP Site Requirements
- 2.4 nano3G S16 AP Site Requirements
- 2.5 nano3G E8 AP and nano3G E16 AP Site Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Configuration File Preparation
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 48
3) Right-click the relevant BSMIS object and select Save Attributes to File. The
Save Attributes Wizard will appear:
4) Tick the check box to Include the descendants of this object. Select To local file
and use the browse button to choose a suitable directory on the client computer for
saving the AP configuration file (the browser dialogue can also create new
directories).
5) When a suitable directory has been selected or created, click Next. The Enter or
amend attributes screen will appear:
6) Select the Scheduled Operation Package and uncheck Lock Allowed as this can
cause service interruption. Click Finish. A confirmation message stating file copied
successfully will appear, click OK.
7) One configuration file will be saved in the directory for each AP object.