User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 2.1 Installation Tasks
- 2.2 Requirements for All nano3G APs
- 2.2.1 General Requirements
- 2.2.2 nano3G AP Cooling
- 2.2.3 Information Required for Pre-Provisioning
- 2.2.4 Parameters for Enterprise Deployments
- 2.2.5 Parameters for Residential Deployments
- 2.2.6 Access Control
- 2.2.7 Closed Access with CSG Parameter Broadcast
- 2.2.8 Closed Access in Legacy Mode
- 2.2.9 Pre-Prepared Configurations - Optional
- 2.2.10 Information Required for Commissioning
- 2.2.11 Other Items for Commissioning
- 2.3 nano3G S8 AP Site Requirements
- 2.4 nano3G S16 AP Site Requirements
- 2.5 nano3G E8 AP and nano3G E16 AP Site Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Commission a nano3G AP
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 53
5.4 Download Activities
If it is necessary to download a software or ATAS package to the AP, this must be done
before configuring the connection to the NOS Server. This is because the ATAS package in
particular may be needed so that the AP can access the NOS Server through the security
gateway. See section 2.2.11 for extra information about software and ATAS packages.
This can only be done if the commissioning terminal is running a web server that provides a
path to any ip.access AP software download packages. That is, the required .sdp files must
be present on the commissioning terminal.
Setting up a web server for this purpose on the commissioning terminal is outside the scope
of this manual.
5.4.1 Optional - Software Download
Use the SW Download page to download a different version of AP software to the AP from
the commissioning terminal to the standby memory bank. Then switch banks to the new
software version, which restarts the AP.
6) Click the SW Download link on the left. The web page for downloading software
will be shown. This also provides details about the current software installed on the
AP.
7) In the text box, enter the URL for the SDP file stored on the commissioning
terminal. For example, the URL of a software file for a nano3G E8 AP might be:
http://192.168.0.2/webservername/220H007_<ver>.sdp
Where <ver> is the actual build version of the required software package.
8) Click Begin Download.