User's Manual

nano3G AP Installation Manual nano3G AP Hardware Installation
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 69
POE Switch and Splitter
In this case, the POE switch is a third-party item. This has similar benefits to using the POE
injector, but a POE switch will typically only be used if there are multiple APs on site and/or
there is other equipment that can take advantage of POE. The supplied POE splitter must
be used with the AP.
Notice that the POE cable to the splitter should not exceed 99.8m in length. This will ensure
that the total cable run from the POE switch to the AP is within the Ethernet limit of 100m.
6.3.4 Mount the nano3G S16 AP
Note: The nano3G S16 AP should be installed in a position so that it is at least 2m away from the
area where handsets are normally used.
The nano3G S16 AP must be mounted vertically in a location that allows air circulation
around the unit. The AP can be mounted in the following ways:
• On a stand
• Directly onto the wall at or above head height
• Onto the splitter unit on the wall at or above head height
The nano3G S16 AP has two holes at the back for direct wall mounting or mounting on the
POE splitter:
Splitter
POE
Switch
S8
AP
POE
(max 99.8m)
Mains Input
LAN
cable
Backhaul
Network to AC
9V DC
cable to AP
(100mm)
LAN cable
(100mm)