User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 2.1 Installation Tasks
- 2.2 Requirements for All nano3G APs
- 2.2.1 General Requirements
- 2.2.2 nano3G AP Cooling
- 2.2.3 Information Required for Pre-Provisioning
- 2.2.4 Parameters for Enterprise Deployments
- 2.2.5 Parameters for Residential Deployments
- 2.2.6 Access Control
- 2.2.7 Closed Access with CSG Parameter Broadcast
- 2.2.8 Closed Access in Legacy Mode
- 2.2.9 Pre-Prepared Configurations - Optional
- 2.2.10 Information Required for Commissioning
- 2.2.11 Other Items for Commissioning
- 2.3 nano3G S8 AP Site Requirements
- 2.4 nano3G S16 AP Site Requirements
- 2.5 nano3G E8 AP and nano3G E16 AP Site Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual nano3G AP Hardware Installation
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 73
6.4 nano3G E8 AP and E16 AP Hardware Installation
6.4.1 Unpack the nano3G E8 AP or E16 AP
1) Unpack the AP and its accessories.
Box contents may vary, but typically the box should contain the following:
• nano3G E8 AP or E16 AP unit with wall bracket attached
• Extraction tool for removing the AP from its wall bracket
• Injector unit for POE+
• Mains cable for the POE+ injector
2) Check that the serial number on the AP unit matches the label on the box.
3) Check that the items have not been damaged in transit.
For any damaged units, contact the supplier immediately for returns advice.
6.4.2 Removable Cable and Antenna Covers
The nano3G E8 AP and E16 AP have two removable covers. The top cover goes over the
antennae, and the bottom cover goes over the cable sockets.
1) Place the unit on a flat surface.