User's Manual

nano3G AP Installation Manual nano3G AP Hardware Installation
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 77
6.4.6 Mount the nano3G E8 AP or E16 AP on a Wall
Note: The nano3G E8 AP or E16 AP should be installed in a position so that it is at least 2m away
from the area where handsets are normally used.
The nano3G E8 AP and E16 AP must be mounted vertically to ensure air circulation around
the unit.
The location of each nano3G E8 AP and E16 AP should be shown on an installation floor
plan produced at the network planning stage. For example, it must take into account that all
APs must be at least 2m from any mobile equipment. The network wiring must be complete
before the nano3G E8 AP or E16 AP can be installed and commissioned. The nano3G E8
AP and E16 AP should be placed on a wall at or above head height.
1) Remove the nano3G E8 AP or E16 AP from the wall bracket. Lay the AP on a flat
surface with the wall bracket upwards. Slide the removal tool over the central fin
between the bracket and the body of the unit to disengage the locking spring, then
slide the bracket to separate it from the AP. The removal tool may be inserted from
the top or bottom of the AP.