User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 2.1 Installation Tasks
- 2.2 Requirements for All nano3G APs
- 2.2.1 General Requirements
- 2.2.2 nano3G AP Cooling
- 2.2.3 Information Required for Pre-Provisioning
- 2.2.4 Parameters for Enterprise Deployments
- 2.2.5 Parameters for Residential Deployments
- 2.2.6 Access Control
- 2.2.7 Closed Access with CSG Parameter Broadcast
- 2.2.8 Closed Access in Legacy Mode
- 2.2.9 Pre-Prepared Configurations - Optional
- 2.2.10 Information Required for Commissioning
- 2.2.11 Other Items for Commissioning
- 2.3 nano3G S8 AP Site Requirements
- 2.4 nano3G S16 AP Site Requirements
- 2.5 nano3G E8 AP and nano3G E16 AP Site Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Finalize Installation
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 82
7.1.2 Download the Latest Software Image from the NOS Server to the
AP
For instructions about how the software images (SDP files) are uploaded to the NOS
Server, see [OPM_440].
1) Select the AP in the NOS Client.
2) Right-click the AP, select Actions and then Perform Software Download. The
Perform Software Download Actions dialogue box will appear.
3) Change the SW Download Operations to Download, Swap and Reboot.
4) Click in the SW Image Download URL box and enter the URL of the required SDP
file using the following URL pattern:
http://<server>/download/sw/<filename>.sdp
Where <server> is the IP address or host name of the required NOS Server, and
<filename>.sdp is the required software download package file.
5) Press <TAB> or <Enter> to set the URL.
6) Click Finish and the download will take place. On the AP, download progress is
indicated by the flashing network LED. When the download is complete, the AP will
reboot under the new software. This may take several minutes.
7) Wait for the AP to be shown as connected to the NOS.
8) Select the 3G AP Admin Package for the AP object and verify that the Filesys
version reported by the Active Software Version matches the SDP file that was
downloaded.