User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 2.1 Installation Tasks
- 2.2 Requirements for All nano3G APs
- 2.2.1 General Requirements
- 2.2.2 nano3G AP Cooling
- 2.2.3 Information Required for Pre-Provisioning
- 2.2.4 Parameters for Enterprise Deployments
- 2.2.5 Parameters for Residential Deployments
- 2.2.6 Access Control
- 2.2.7 Closed Access with CSG Parameter Broadcast
- 2.2.8 Closed Access in Legacy Mode
- 2.2.9 Pre-Prepared Configurations - Optional
- 2.2.10 Information Required for Commissioning
- 2.2.11 Other Items for Commissioning
- 2.3 nano3G S8 AP Site Requirements
- 2.4 nano3G S16 AP Site Requirements
- 2.5 nano3G E8 AP and nano3G E16 AP Site Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Finalize Installation
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 84
Modified Stored Configuration Attributes
1) Select the Stored Configurations object under Network Orchestration System
node. The attributes for this Managed Object are displayed in the properties pane:
2) Select the Stored Configuration Package.
3) Edit the attributes of the Stored Configuration Package. The configurable
attributes of this managed object are:
4) Click Apply to save the changes, click Cancel to abandon any changes.
Configuration Timeout This attribute specifies in hours how long a
gap between two amendments to the same
managed object or group of objects counts
as long enough that the later modification
creates a new stored configuration
Maximum Number of Configurations Specifies the maximum number of stored
configurations that will be kept for each
managed object or group of objects for
which configuration Rollback is possible