User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 2.1 Installation Tasks
- 2.2 Requirements for All nano3G APs
- 2.2.1 General Requirements
- 2.2.2 nano3G AP Cooling
- 2.2.3 Information Required for Pre-Provisioning
- 2.2.4 Parameters for Enterprise Deployments
- 2.2.5 Parameters for Residential Deployments
- 2.2.6 Access Control
- 2.2.7 Closed Access with CSG Parameter Broadcast
- 2.2.8 Closed Access in Legacy Mode
- 2.2.9 Pre-Prepared Configurations - Optional
- 2.2.10 Information Required for Commissioning
- 2.2.11 Other Items for Commissioning
- 2.3 nano3G S8 AP Site Requirements
- 2.4 nano3G S16 AP Site Requirements
- 2.5 nano3G E8 AP and nano3G E16 AP Site Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Troubleshooting
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 92
8.3.3 nano3G E8 AP and nano3G E16 AP Factory Reset
1) Use a thin rod to press and hold the reset button.
2) Keep the reset button pressed until the 3G LED changes from blinking fast (50ms
on, 50ms off) to blinking slowly (200ms on, 200ms off).
The 3G LED blinks fast (50ms on, 50ms off) until the factory reset commences,
then it blinks slowly (200ms on, 200ms off). When the factory restore process is
complete, the LED extinguishes and the AP automatically reboots, takes the fixed
IP address and enables the web interface for commissioning.
3) If required, use a connected commissioning terminal to login to the AP’s web
interface. The login to the web interface is only available for 60 seconds. If the AP
times out, it will boot up using the default set of parameters, as per the current
entries on the commissioning web page.
4) See section 5 for the commissioning procedure.