Installation Instructions

nanoLTE S60 AP Hardware Installation nanoLTE S60 AP Hardware Installation
NANO_INST_43315 v200_0.5 for N4G_2.0 © ip.access Limited 2017 Page 8
3 nanoLTE S60 AP Hardware Installation
3.1 Unpack the S60 AP
1) Unpack the AP and its accessories.
Box contents may vary, but typically the box should contain the following:
• S60 AP unit with wall bracket attached
• Tabletop stand
• Mains power supply unit with plug adaptors
• Ethernet cable (approx 2m)
2) Check that the serial number on the AP unit matches the label on the box.
3) Check that the items have not been damaged in transit.
For any damaged units, contact the supplier immediately for returns advice.
3.2 Cable Connections
The nanoLTE S60 AP requires an Ethernet cable connection to the backhaul and power
from the mains via the supplied power adapter:
A mains socket providing power to the AP must be within reach of the cabling included with
the PSU. This is typically less than 1.5m. Use the PSU supplied for use with the S60 AP.
Note: The nanoLTE S60 AP cannot be powered with PoE or PoE+. The presence of power on the
Ethernet connection has no effect on the S60 AP.
PSU
S60 AP
LAN Cable to
nearest switch/gateway
(max 100m)
Mains
Input
12V DC
cable to AP
Backhaul
Network to
NOS and
EPC/S1GW